PLM SOPs: Design Sample Requests - Commenting on a 4 PC TEST - STEP BY STEP

Steps to take when commenting on a 4 PC TEST in PLM:

1. Identify the design you will be working in.

2. Navigate to the "Sample Requests" section of the design profile.

3. Once in the "Sample Requests" section of the design, click into the "In Progress" 4 PC. Test that you will be making comments on:

4. Here, please fill out below fields:

- Review Date

- Review By

- Receive By

- Receive Date

You also have the option to:

- Select the Tech Pack that was shared with the Partner when requesting this sample set.

- Have filled out the Estimate Ship Date, Actual Ship Date, Carrier and Tracking Number.

In the Notes Section (at the top right of page,) please fill out your comments:

In the Measurements Section, (at the bottom of the page,) please fill out the measurements of each sample.

**Ensure that you DO NOT CLICK the "Sync with Meas" button.

In the Images Section, add in an image or images of each sample:

5. Once all is filled out and comments are made in notes section, change the sample status from "In Progress" to "Approved w/ Comments"

6. Click "Update"

7. You will prompted with below message. Click "OK"

Congratulations, you have successfully updated and "Approved w/ Comments" a 4 Pc. Test Sample Request.

You are now ready to create a TP to share these comments, and request a FIRST LOAD.